Cascade Continuous Stirred Tank Reactor (Compressed Air Feed System)

MODAL NO: MTCRE-103A

QTY


CRE Lab- homogeneous

In an ideal CSTR (i.e. an ideal steady state flow reactor) the contents in reactor This set-up is used to study a non-catalytic homogeneous second order liquid phase reaction under ambient condition. The setup consists of three CSTR arranged in series and two feed tanks through which two reactants are fed to the reactor. Rotameters are provided to measure the individual flow of Chemicals. 

CRE Lab- homogeneous

In an ideal CSTR (i.e. an ideal steady state flow reactor) the contents in reactor This set-up is used to study a non-catalytic homogeneous second order liquid phase reaction under ambient condition. The setup consists of three CSTR arranged in series and two feed tanks through which two reactants are fed to the reactor. Rotameters are provided to measure the individual flow of Chemicals. The flow rate can be adjusted by operating the needle valves provided on respective Rotameter. The compressed air is used for circulation of feed. Reactants from feed tanks enter in the first CSTR and are passed to second CSTR and so on. For analysis samples are collected from different ports provided. Pressure Regulator, Pressure Gauge and Safety Valve are fitted in the compressed air line. 

EXPERIMENTATION:

To study the performance of Cascade of three equal volumes CSTR's in series for the sponification of a reaction. 

To draw the performance chart for the reactor system and evaluate the reaction rate constant at ambient condition. 

UTILITIES REQUIRED :

Electricity Supply: Single Phase, 220 V AC, 50 Hz, 5-15 Amp combined socket with earth connection. Earth voltage should be less than 5 volts. 

Compressed Air Supply: 0.5 CFM@1bar 

Water Supply. 

Floor Area Required: 1.5 m x 0.75 m 

Floor Drain.

Instruments, Laboratory Glassware and Chemicals required for analysis as per the system adopted. 

Reactor (3Nos.) : Material Stainless Steel, Capacity 1 Ltr.(Approx.)

Stirrer (3Nos.) : Stainless Steel Impeller and shaft coupled with FHP Motor.

Feed Tank (2Nos.) : Material Stainless Steel, Capacity - 20 Ltrs. (Approx.)

Feed Circulation : By compressed air.

Flow Measurement : Rotameter-2Nos. (one each for Reactants).

Piping : Stainless Steel and PU pipe

Pressure Regulator : 0-2 Kg/cm2

Pressure Gauge : Bourdon type 0-2 Kg/cm2

Control Panel comprising of : Standard make on/off switch, Mains Indicator etc.

An ENGLISH instruction manual consisting of experimental procedures, block diagram etc. will be provided along with the Apparatus

The whole set-up is well designed and arranged on a rigid structure painted with industrial PU Paint. 

Related Products