The setup consists of Bonnotto type extractor of slotted circular plates arranged one above the other in opposite radial opening. The solids are introduced at the top through a hopper spread over the top plate by a rack and pushed to slot to fall to the next plate below and so on to the bottom of the column. The solvent is introduced near the bottom of the column and it flow upward counter-currently to the solids.
The setup consists of Bonnotto type extractor of slotted circular plates arranged one above the other in opposite radial opening. The solids are introduced at the top through a hopper spread over the top plate by a rack and pushed to slot to fall to the next plate below and so on to the bottom of the column. The solvent is introduced near the bottom of the column and it flow upward counter-currently to the solids. A pump supplies the solvent and flow rate is monitored by means of a Rotameter. At the bottom of column a screw conveyor arrangement is done to remove the extracted solids driven by means of an electric motor. Solvent feed tank is kept in a bath fitted with heater and digital temperature controller is used to maintain the constant temperature.
•An ENGLISH instruction manual consisting of experimental procedures, block diagram etc. will be provided along with the Apparatus.
•The whole set-up is well designed and arranged on a rigid structure painted with industrial PU Paint.
Experimentation
To determine the efficiency of a continuous counter-current Solid-Liquid Extraction system.
Utilities Required
Electricity Supply: Single Phase, 220 V AC, 50 Hz, 5-15 Amp combined socket with earth connection. Earth voltage should be less than 5 volts.
•Water supply
•Floor area required:
•Solvent : 50 ltrs.
•Solid : 30 kg.
Extraction Column | Material Stainless Steel Dia. 150 mm, Height 750 mm (approx.) |
Plates | Material Stainless Steel, with Radial opening. |
Mixer | Material Stainless Steel Impellers fitted on Stainless Steel Shaft coupled to a motor & reduction gear box. |
Screw Conveyor | Material Stainless Steel, Compatible capacity, housed in GI Pipe and driven by a motor & reduction gear box. |
Solvent Flow Measurement | By Rotameter. |
Solvent Tank | Made of Stainless Steel, Capacity 30 Ltrs. Double walled. |
Feed circulation | By Magnetic Pump, made of Polypropylene for solvent. Maximum working temperature 60°C. |
Heater | Nichrome wire heater. |
Feed Hopper | Suitable capacity. |
Filtration Sieve | Material Stainless Steel. |
Receiving Tank for | Material Stainless Steel, Extracted solid waste Compatible capacity. |
Temperature Sensor | RTD PT-100 type |
Digital Temp. Controller | PID Controller, 0-199.9°C, For Feed Tank Standard make on/off switch, Mains Indicator etc. |