TO DETERMINE THE MODULUS OF RIGIDITY OF A WIRE BY STATICAL METHOD, USING BARTON’S APPARATUS manufacturer in india
A steel frame mounted on a heavy cast iron base with leveling screws. Upper end of the rod (under test) 900mm length and 5mm dia is clamped by a 3-jaw chuck and the lower end is clamped into the axis of a torsional drum which can be rotated by putting load in the scale pan passing over two frictionless pulleys. Freely sliding three circular scales graduated in single degrees can be clamped at any position. Three pointers for clamping to the test rod are provided. Complete with three other rods, strings and two scale pans, but without weights.
TO DETERMINE THE MODULUS OF RIGIDITY OF A WIRE BY STATICAL METHOD, USING BARTON’S APPARATUS manufacturer in india
A steel frame mounted on a heavy cast iron base with leveling screws. Upper end of the rod (under test) 900mm length and 5mm dia is clamped by a 3-jaw chuck and the lower end is clamped into the axis of a torsional drum which can be rotated by putting load in the scale pan passing over two frictionless pulleys. Freely sliding three circular scales graduated in single degrees can be clamped at any position. Three pointers for clamping to the test rod are provided. Complete with three other rods, strings and two scale pans, but without weights.
SCOPE OF LEARNING:
• To Determine The Modulus Of Rigidity of a Wire By Statical Method, Using Barton’s Apparatus
• APPARATUS USED:
• Barton’s Apparatus
• Slotted Weights 500gmx5
• Screw Gauge 20x1mm (Optional)
• Vernier Caliper (Optional)
• Measuring Tape (Optional)
TO DETERMINE THE MODULUS OF RIGIDITY OF A WIRE BY STATICAL METHOD, USING BARTON’S APPARATUS manufacturer in india
Enquiry Cart (