SPECIFICATION:

S.N. Particular

1 Training system control panel having rating of 500 VA and it should be used as solar training system and also power generation as well.

2 Training system control panel should have built in DC voltmeters, DC ammeters, AC Voltmeter  AC multifunction  meter(for AC current, voltage, power, frequency)

3 Training should have control panel built in protection circuit for battery & solar panel

4 Training system control panel have built in 30A terminals for making the connection

5 Training System includes 250Wp solar panel: 2 Nos., Battery 100Ah: 2 Nos., PCU (POWER AND CHARGE CONTROLLER UNIT): 1 No. , Control panel for experiments equipped with meters, connecting terminals and switches

6 Solar Panel: 02 Nos.

 Pm : 250Wp,Voc : 43V,Isc : 7.75A,Vmp : 35V,Imp : 7.14A

7 POWER AND CHARGE CONTROLLER UNIT 

Inverter Capacity 600VA and  Input Voltage 190~260V AC, Output Voltage on Mains mode is  same as input, Output Voltage on UPS mode 210~245V,Output Frequency on UPS mode  50Hz ±0.1Hz,Output waveform on Mains mode is same as input, Output waveform on UPS mode  Modified Sine wave, Battery Charging Current 12A,Efficiency at full load  >80%, UPS overload and short circuit facility is  available  , control panel  design based Microcontroller, MCB : C Type 16A

8 Battery: 02 Nos.  Solar Battery of Capacity: 12V/100Ah, Type : C10

9 Charge Controller Technologies:  Solar PV Module : 24–50V,Current : 40A,Battery voltage : 24V,Technology : PWM based   MPPT, Charging Stage : Bulk, Absorptions and Float 

10 Meter specification : DC Voltmeter : 0-300V ; DC Ammeter : 0-40A ; Multi Function Meter : Voltage-10-230V  ; Current-100mA-5A ; Watt-10-1200W ; Energy meter Display Resolution-  0.001kWh ; Frequency-50Hz

11 Training platform used to conduct below experiment  

a Measurement and Analysis of Different parameters of Solar  PV Module : open circuit and short circuit, parameter measurement with series and parallel PV modules , I-V characteristic and Power curve   of PV module and PV array ., efficiency and fill factor

b Load Estimation and calculation

c Study of Charge controller 

d Study of different parameter of inverter  efficiency , PWM switching , charging of batteries , over load and over battery protection 

STANDARD ACCESSORIES : Main cord , Patch cord, Operating manual

ELECTRIC SUPPLY SPECIFICATION: AC 240 v