SCOPE OF LEARNING:
• Study and Construction of Various Digital Electronics Lab Experiment
SALIENT FEATURES:
• Front Panel Built With High Class Insulated Printed Circuit Board Sheet With Printed Circuits & Symbols.
• Fuse For Short Circuit Protection
• Instruction Manual.
• Connections are brought out through 2mm Brass Sockets.
• Patch Cords 2mm.
• The trainer is housed in ABS Plastic cabinet.
• Size of the trainer set 12”x10”
OPTIONAL ACCESSORIES:
• No
TECHNICAL SPECIFICATIONS:
Power Supplies:
• Dc Power Supply IC Regulated +5V DC, 1A.
• Operated On Mains Power 230v, 50hz +10%
Logic Gates:
1. OR Gate 4 Nos.
2. And Gate 4 Nos.
3. Not Gate 6 Nos.
4. Nand Gate 4 Nos.
5. Nor Gate 4 Nos.
6 Ex-Or Gate 4 Nos.
• Adder And Subtractor Using 7483
1. Full Adder
2. Full Subtractor
• Flip Flop :
JK Flip-Flop Using 7476 2 Nos.
D Latches Using 7474 2 Nos.
• 20 Pin Zip Socket
• Buzzer as Continuity Tester
• Variable Resistor 10K Ohm.
• Logic Inputs & Outputs 8 Bit
• Trainer Contains 4 Bit BCD To 7 Segment Indicators With Inputs A, B, C, D Inputs.
• Logic Low Frequency Mono Pulsar.
• Low Frequency Clock Generator 1Hz-10Hz.
• Breadboards: Unique solder - less large size, spring loaded breadboard consisting of one Terminal Strips with 640 tie points each and 2 Distribution Strips with 100 tie points each, totaling to 840 tie points. (Size: 55mm X 170mm approx).