SCOPE OF LEARNING:
• Study of Speed Control of Stepper Motor by Interfacing uController
• Fast & slow by assembly language programming
• Forward & reverse by assembly language programming
• Free run & step by assembly language programming
SCOPE OF LEARNING:
• Study of Speed Control of Stepper Motor by Interfacing uController
• Fast & slow by assembly language programming
• Forward & reverse by assembly language programming
• Free run & step by assembly language programming
SALIENT FEATURES:
• Front panel built with high class insulated Printed Circuit Board sheet with well printed circuits and symbols.
• Instruction manual.
• Connections are brought out through 10 pin FRC Connector.
• Patch Cords 10pin FRC Female Connector.
• The trainer is housed in High Class Insulated Plastic cabinet.
• Size of the trainer set 12”x10”
OPTIONAL ACCESSORIES:
• No
TECHNICAL SPECIFICATIONS:
Power Supply:
• IC regulated +5V and +12V DC at 1A
• Operated on Mains power 230V, 50Hz +10%
Components are mounted on the panels are:
• RS232 Interface using Max232 given on board for interfacing between PC and Trainer.
• 08. Driver NXP 89V51Rd2
• Adequate nos. of other electronic components.
• DC Stepper Motor 6 winding torque 1.0 Kg-cm, step angle 1.8º, power 12V 0.2 Amp/ phase
• One 16x2 LCD provide on board.