Enquiry now

Isothermal Continuous Stirred Tank Reactor Compressed Air Feed System manufacturer in india

MODAL NO: MTCRE-102A

QTY


CRE Lab- homogeneous

In an ideal CSTR (i.e. an ideal steady state flow reactor) the contents in reactor are well mixed and have uniform composition throughout. Thus the exit stream has the same composition as the fluid within the reactor. This type of reactor is known as mixed flow reactor. This set-up is used to study a non-catalytic homogeneous second order liquid phase reaction under isothermal condition. 

CRE Lab- homogeneous

In an ideal CSTR (i.e. an ideal steady state flow reactor) the contents in reactor are well mixed and have uniform composition throughout. Thus the exit stream has the same composition as the fluid within the reactor. This type of reactor is known as mixed flow reactor. This set-up is used to study a non-catalytic homogeneous second order liquid phase reaction under isothermal condition. The set up consists of two feed tanks through which two reactants are fed to the reactor. Rotameters are provided to measure the individual flow of Chemicals. The flow rate can be adjusted by operating the needle valves provided on respective Rotameter. The compressed air is used for circulation of feed. The CSTR is fitted with stirrer for proper mixing. From top outlet of it samples are collected for analysis. Constant temperature water bath arrangement is provided to conduct the experiment at various temperatures. Pressure Regulator, Pressure Gauge and Safety Valve are fitted in the compressed air line.

Saponification Reaction study in Isothermal CSTR. To determine the Reaction Rate Constant and effect of temperature on it.

  • Electricity Supply: Single Phase, 220 V AC, 50 Hz, 5-15 Amp combined socket with earth connection. Earth voltage should be less than 5 volts. 
  • Compressed Air Supply: 0.5 CFM@2 Bar
  • Water Supply. 
  • Floor Drain.
  • Floor Area Required: 1 m x 0.75 m.

Instruments, Laboratory Glassware and Chemicals required for analysis as per the system adopted. 

  • Reactor : Material Stainless Steel, Capacity 2 Ltrs. (Approx.)
  • Water Bath : Material Stainless Steel, Double wall, insulated with Ceramic Wool
  • Heater : Ni-chrome wire Heater
  • Stirrer (2Nos.) : Stainless Steel Impeller and shaft coupled with FHP Motor (One each for Water Bath and Reactor).
  • Feed Tank (2Nos.) : Material Stainless Steel, Capacity- 20 Ltrs. (Approx.)
  • Feed Circulation : By compressed air.
  • Flow Measurement : Rotameter-2Nos. (One each for Reactants).
  • Piping : Stainless Steel and PU pipe.
  • Pressure Regulator : 0-2 Kg/cm2
  • Pressure Gauge : Bordon type 0-2 Kg/cm2
  • Temp. Sensor : RTD PT-100 type
  • Control panel comprises of :
  • Digital Temp. Controller : PID Controller, 0-199.9°C (For Hot Water Bath)

With Standard make on/off switch, Mains Indicator etc.

An ENGLISH instruction manual consisting of experimental procedures, block diagram etc. will be provided along with the Apparatus. The whole set-up is well designed and arranged on a rigid structure painted with industrial PU Paint.

Related Products